1.
What is split horizon?

2.
Which statement is true regarding classless routing protocols?
1. The use of discontiguous networks is not allowed.
2. The use of variable length subnet masks is permitted.
3. RIPv1 is a classless routing protocol.
4. IGRP supports classless routing within the same autonomous system.
5. RIPv2 supports classless routing.

3.
Which command displays RIP routing updates?

4.
Which of the following statements are true regarding the command ip route 172.16.4.0 255.255.255.0 192.168.4.2?
1. The command is used to establish a static route.
2. The default administrative distance is used.
3. The command is used to configure the default route.
4. The subnet mask for the source address is 255.255.255.0.
"""

5.
If your routing table has a static, a RIP, and an IGRP route to the same network, which route will be used to route packets by default?

6.
The Corporate router receives an IP packet with a source IP address of 192.168.214.20 and a destination address of 192.168.22.3. Looking at the output from the Corporate router, what will the router do with this packet?
 Corp#sh ip route [output cut] R    192.168.215.0 [120/2] via 192.168.20.2 00:00:23 Serial0/0 R    192.168.115.0 [120/1] via 192.168.20.2 00:00:23 Serial0/0 R    192.168.30.0 [120/1] via 192.168.20.2 00:00:23 Serial0/0 C    192.168.20.0 is directly connected Serial0/0 C    192.168.214.0 is directly connected FastEthernet0/0 
"""

7.
You type debug ip rip on your router console and see that 172.16.10.0 is being advertised to you with a metric of 16. What does this mean?""

8.
Two connected routers are configured with RIP routing. What will be the result when a router receives a routing update that contains a higher-cost path to a network already in its routing table?

9.
What command is used to stop RIP routing updates from exiting out an interface but still allow the interface to receive RIP route updates?

10.
Which two of the following are true regarding the distance-vector and link-state routing protocols?
1. Link state sends its complete routing table out all active interfaces on periodic time intervals.
2. Distance vector sends its complete routing table out all active interfaces on periodic time intervals.
3. Link state sends updates containing the state of its own links to all routers in the internetwork.
4. Distance vector sends updates containing the state of its own links to all routers in the internetwork.

error: Content is protected !!