1.
When creating a pool of global addresses, which of the following can be used instead of the netmask command?""

2.
Pat Address Translation is also termed what?

3.
Which command would you place on interface on a private network?

4.
Which command will show you all the translations active on your router?

5.
Which command would you place on interface connected to the Internet?

6.
Which are considered the methods of NAT?
1. Static
2. IP NAT pool
3. Dynamic
4. NAT double-translation
5. Overload

7.
Which of the following is considered to be the address after translation?

8.
Which of the following is considered to be the destination host before translation?

9.
Which command will show you the summary of the NAT configuration?

10.
Which of the following would be a good starting point for troubleshooting if your router is not translating?

error: Content is protected !!